The “Source” vertical list of coloured spheres, graphically represents the list of all the available audio sources. Click on one of those spheres to select it. This selection is valid for all the See’n’Sound LE windows and let you edit all the audio source parameters for the selected source/sphere.
The “Edit/Lock” vertical list of sliders, lets you permit or denied the edit of the horizontally related audio source’s parameters.
Click on one circle arrow icon in the “Loop” vertical list of buttons to repeat the horizontally related audio source an undefined number of times, till the end of the See’n’Sound LE session. If no button is pressed in the “Loop” list, each audio file will be played entirely only one time.
Click on the on word beside one “Mute” slider to temporarily set the volume of the horizontally relative source to zero. Click on the off word on the slider opposite side to restore the volume original value.
In the trasport area you can find the classic Play button. Click on it to start playback, click again to pause the reproduction. Click on Stop button to stop playback and go back to start position.
The buttons with the two arrows icons let you, respectively, to go back to start, to go back one frame, to go forward one frame and to reach immediately the end of the session.
The long slider in the bottom lets you quickly move forward or back through the See’n’Sound LE session, and the SMPTE field above on the right indicates the value in hours, minutes, seconds and frames of the selected frame.